The stepper controller circuit is very interesting, since most lines the step motor controllers
are very expensive. The circuit is made of standard components and
can easily be adjusted by a computer. If you cheap surplus transistors
and stepper motors, the price of the circuit can be less than $ 15.
 |
| Stepper Motor Controller Circuit using IC 4027 |
This
stepper controller circuit shown here can used to control the unipolar stepper motor,
the which has four coils. The stepper controller circuit can drive for a
motor current of up to about 500 MAMP / Winding by Suitable heat sinks
for the SL-100 In higher currents seem 2N3055 power transistors can be
used as darlington pair along with the SL-100. All diodes are used to
protect the transistor from back current transients.
List Componet
R1, R2 ,R3, R4: 1K 1/4W Resistor
D1, D2, D3, D4: 1N4002 Silicon Diode
Q1, Q2, Q3, Q4: TIP31 NPN Transistor (See Notes) TIP41, 2N3055
U1 : 4070 CMOS XOR
U2 : 4027 CMOS JK Flip-Flop
S1 : SPDT Switch
Notes:
1. You should be able to substitute any standard (2N3055, etc.) power transistor for Q1-Q4.
2. Every time the STEP line is pulsed,
the motor moves one step.
3. S1 changes
the motors direction.
 |
| 4027 CMOS JK Flip-Flop IC Pinout |
 |
| 4070 CMOS XOR IC Pinout |
